Cut and trim the ceiling inserts to fit. We provide inserts that are extra long to fit all containers.
Use a razor knife to trim for the contours for the outside edges. Alternatively if you do not want to razor trim each insert you can use spray foam to fill the outer insert contours.
Apply adhesive in an “S” pattern. Brace the insert until the glue sets. The inserts can be braced with the flat panels holding them in place.
Apply an even bead of Pl Premium to the Ceiling Insert in an “S” pattern.
Brace the insert until the glue sets. The inserts can be braced with the flat panels holding them in place.
Important Notice about Adhesive:
Moisture is Necessary for Adhesive. When applying adhesive to the InSoFast studs, spray a fine water mist over the wet beads of adhesive following the adhesive manufacturer’s instructions. Use a plant mister bottle to provide a light atomized spray. The addition of moisture to the adhesive will allow the cure process to be activated. When bonding EPS and XPS foam insulation, use above 40°F (4°C) and avoid cure and surface temperatures above 90°F (32°C). Surfaces must be clean, dry and free of frost, grease, dust and other contaminants. Pre-fit all materials and protect finished surfaces. If using cartridge format, cut nozzle at a 45° angle to desired bead size and puncture inner seal. Be very careful not to allow Loctite® PL® Premium to cure on a finished surface.